>> John Baldwin <[email protected]> wrote: > On Wednesday, September 26, 2012 6:42:19 pm Garrett Cooper wrote: >> On Wed, Sep 26, 2012 at 3:33 PM, Olivier Cochard-Labbé >> <[email protected]> wrote: >> > On Thu, Sep 27, 2012 at 12:10 AM, Marcin Cieslak <[email protected]> wrote: >> >> I have just updated by 9.0-something laptop to 10.0-CURRENT r240948 >> >> and it very quickly panics after enabling network with IPsec >> >> (I am using IPsec w/racoon for IPv4 over 802.11, also using >> >> tunelled IPv6). >> > >> > I don't know if it's related, but one of the first dmesg message >> > displayd on my -current (rev 240921) is: >> > >> > module_register: module enc already exists! >> > Module enc failed to register: 17 > > I suspect this is the root cause and that the "wrong" global variable is > being > used in ipsec_output.c due to duplicate symbols.
As the original poster: I don't have this "module enc already exists!" message. I have had "device enc" in the kernel config file and I didn't try to load if_enc as module. I have IPSEC permanently enabled in the kernel and it is initialized at boot with setkey and later with racoon. > OTOH, have you created an enc0 device? I can't find anything that > automatically creates it. No. Previously, in 9.x times, it was always present in the ifconfig output. I was also looking for anything that initializes enc0 but couldn't find it. //Marcin _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[email protected]"
