Hi,
I use the same method, and I have about 15 VLANs.
I have ALTQ active on fxp1 interface (where all VLANs are sitting),
and I assign traffic to altq depending on which vlan interface it
arrives/goes. This way the bandwidth can be shared between VLANs
easily.
Regards,
On 1/27/06, husnu demir <[EMAIL PROTECTED]> wrote:
> Hi,
>
> Last week I tried to use PF+ALTQ+VLAN combination and found out that ALTQ
> doesnot support VLAN. Then after some searching found out that giving ALTQ
> support on the root device and queue'ing to the VLAN device is sufficient to
> use. But I could not find any reference for that info, either pf.conf or ALTQ
> manual. man altq says that
>
> " The tun(4) and ng_iface(4) pseudo drivers also do support ALTQ"
>
> but does not mention about the vlan. Is this solution correct? If it is, whay
> anybody did not reference to that INFO.
>
>
> Thanks.
>
>
> ....
> altq on bge0 cbq bandwidth 0.05Mb queue { icmp } # BGE0 is the main
> interface for VLAN1.
> queue icmp_internal cbq(default)
> ....
>
> pass in quick on vlan1 inet proto icmp from xxxxxxxx to any \
> icmp-type $icmp_tips keep state (max 1000) queue icmp_internal #
> queue is used for the VLAN1 interface.
> ....
--
Claudiu Dragalina-Paraipan
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-pf
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
