On Fri, Aug 29, 2008 at 06:54:23AM -0400, ben wilber wrote: > I'm trying to use PF on a machine with an mxge(4) interface and am > having some difficulty. With my ruleset loaded, any TCP session that > gets a state grinds to a halt. > > For example, I can log in via SSH and issue commands that return a > couple lines, but the output from a command like dmesg(8) comes very > slowly and sometimes won't finish before SSH times out. MTU on the > interface is 1500 bytes. This doesn't happen unless states are created > (e.g., not with "pass no state"). > > The machine is running -CURRENT for amd64 as of Jul 18th compiled with > ALTQ, crypto and IPSEC, HZ=1000 and DEVICE_POLLING (though not enabled). > IP and IPv6 forwarding are enabled, as well as fastforwarding. Only > filtering; no bridges, ALTQ, NAT or scrubbing. > > Any insight?
I've seen this problem on RELENG_6, although the SSH connections would not "time out" -- after a page or so of 'dmesg' output, they would immediately get disconnected/severed. I believe the problem was caused by my use of "modulate state" instead of "keep state" (since on RELENG_6 "keep state" is not implicit). Are you using "reassemble tcp", "synproxy state", or "modulate state" directives? Does disabling RFC1323 (see sysctl) make a difference at all? Are you blindly filtering all ICMP traffic and destroying PMTU negotiation? Can you provide your pf.conf? -- | Jeremy Chadwick jdc at parodius.com | | Parodius Networking http://www.parodius.com/ | | UNIX Systems Administrator Mountain View, CA, USA | | Making life hard for others since 1977. PGP: 4BD6C0CB | _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-pf To unsubscribe, send any mail to "[EMAIL PROTECTED]"
