I have a WatchGuard Firebox II that I've been working on turning into a decent router. I see many people have installed monowall (http://m0n0.ch/wall/) on these boxes with good success. I would be done myself unless I was setting up a wireless bridge.
These boxes are basicly custom pentium 200's with 3 ethernet ports, a few serial ports, 2 pcmcia card slots, a 44pin ide header, a keyboard header, and 2 backwards facing pci slots. The problem I am having is with getting a pc card to be detected, it knows they're there, it just wont register them. First off, I'm new to BSD. Second, I know this is not straight up BSD, but if given direction I can make anything happen that needs to for testing, I have a 5.3 box setup for testing, altho I'm having trouble getting it to boot on the firebox ( i need to recompile and disabe psm0 detection) Anyway, this is what I'm seeing. pci_cfgintr: can't route an interrupt to 0:16 INTA pcic0: <TI PCI-1225 PCI-CardBus Bridge> at device 16.0 on pci0 pcic0: PCI Memory allocated: 0x88000000 pci_cfgintr: can't route an interrupt to 0:16 INTA pcic0: No PCI interrupt routed, trying ISA. pcic0: Polling mode pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][CSC serial isa irq] pccard0: <PC Card 16-bit bus (classic)> on pcic0 pci_cfgintr: can't route an interrupt to 0:16 INTB pcic1: <TI PCI-1225 PCI-CardBus Bridge> at device 16.1 on pci0 pcic1: PCI Memory allocated: 0x88001000 pci_cfgintr: can't route an interrupt to 0:16 INTB pcic1: No PCI interrupt routed, trying ISA. pcic1: Polling mode pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][CSC serial isa irq] pccard1: <PC Card 16-bit bus (classic)> on pcic1 pmtimer0 on isa0 I've google'd and google'd and poked and prodded, I've added the following to /boot/loader.conf, with no success. hint.acpi.0.disabled=1 hw.cbb.start_memory=0x20000000 If you want a look at the kernel config it is located here. (this is for monowall, not my 5.3 box, that has yet to be recompiled) http://m0n0.ch/wall/downloads/freeb...0N0WALL_GENERIC Any suggestions on where to go next? If you need any output, or anything, let me know. Thanks in advance, Tony _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"