Keith Bottner wrote:

Ok I find the lines that related to skc in the /var/run/dmesg.boot and they
are included below:

skc0: <Linksys EG1032 Gigabit Ethernet> port 0xe800-0xe8ff mem
0xfbfffc00-0xfbfffcff irq 11 at device 9.0 on pci2
skc0: failed: rid 0x10 is ioport, requested 3
device_attach: skc0 attach returned 6

The second line says failed but I don't where it says anything regarding
why. Any ideas?
Well, it *does* say why, you just don't understand what it is saying. Nor do I ;-)

I suggest you try on the hardware list, try filing a PR, or be bold and email the author of the driver. PR is probably the recommended route, but don't quote me.

Just to be clear, if the device is not attaching then nothing you do with pciconf or in any config file will make any difference.

You could also try:
   google for your specific error "rid 0x10 is ioport"

If this is 5.4, try downloading and booting from 6.0 CD (just CD1 should be required) and see if that spots it. When you get into sysinstall you can hit "Pause" then "Page Up" to see the boot log. If this is 6.0 then vice versa! Your card is listed as apparently 5.4 compatible, but manufacturers just go and change things so cards which worked in one revision, fail in another.

--Alex

_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to