I set up several of these every few months (I teach at a college where we teach students to configure serial lines on 2500s). The most common problems I see are encapsulation mismatch, no clockrate set or set wrong, and I've even seen line protocol down when there is no IP configured...but I think that was a PEBKAC problem. Chances are your line is fine, and you have to take this up with your ISP. I'd email them or read them your config for that interface and have them confirm that it's right, and have them double check theirs.
Hope I Helped, --Brian -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Wayne Swart Sent: Wednesday, December 18, 2002 2:41 AM To: FreeBSD Mailing list Subject: My Cisco Problem Lo, tis me again :) I not placed the NTU (terminating unit) on my side in loopback mode. Now i get: Serial1/7 is up, line protocol is down (looped) Do i take it the problem is on my router then hey? thnks wayne To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-questions" in the body of the message To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-questions" in the body of the message
