Try the bios ? > Sebastian wrote: > >> Markus Trippelsdorf wrote: >> >>> Are you sure that your hard drive is not dying? Run smartctl -a >>> /dev/ad0 and see if any errors were being logged. >>> (smartctl is part of the smartmontools port) >>> You should also try another cable. >>> >>> >> Thanks for the response. I'm reasonably sure, the disk is brand new, >> and though it could certainly be bad, I installed Linux on the system >> this morning without issue. I've tried two different UDMA cables also, >> just to be sure. Under PIO4 mode in BSD (by setting hw.ata.ata_dma=0), >> I can install and then write data to my heart's content without any >> errors. >> >> I'm currently reinstalling again, because I believe a partition has >> become corrupted after panicking with the disk in UDMA6 mode. >> > > Just as a followup: Attempting to run "atacontrol mode ad0 UDMA6" > resulted in WRITE_DMA48 errors and a panic. Afterwards, disk access was > slow, and trying to use _any_ UDMA mode resulted in DMA errors being > logged, and eventually another panic. > > Having briefly tested UDMA3-5 with success previously, I felt that the > partitions must have been corrupted somehow, so I reinstalled FreeBSD > from scratch. It's better, after booting with "hw.ata.ata_dma=0" and > then running "atacontrol mode ad0 UDMA5", it's running fine using UDMA5 > and copying lots of data around: > # atacontrol mode ad0 > current mode = UDMA100 > > So my question remains: How do I tell FreeBSD to use UDMA5 on this drive > at boot-time? > > Thanks. > > _______________________________________________ > freebsd-questions@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to > "[EMAIL PROTECTED]" >
_______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"