If the SCSI is enabled you should get a boot message and be able to go into
the SCSI configuration.
All SCSI controllers will list the devices found on boot, so if you aren't
seeing any devices you don't have it working right. Check the BIOS again
and check your cabling, and termination.
-Derek
At 09:49 AM 3/4/2006, David LeCount wrote:
Okay, now we're getting somewhere (maybe). Looking in
the CMOS for firewire, I finally found the SCSI
controller setting. I never would have guessed it
would be under PCI configuration. Anyway, I enabled
that, and I disabled firewire, both ethernet ports (I
use wireless anyway), and both SATA channels. I'll
have to enable one of the SATA channels later since I
have a new SATA drive, but for now I want to keep it
as simple as possible. Also, I have the mpt device
built into my kernel, along with scbus and da. Still,
FreeBSD does not list a da device, dmesg doesn't show
anything about mpt, and there is no information
displayed on boot about SCSI drives. It's as if the
SCSI controller is still disabled, even though I
enabled it and saved settings. (I went back into CMOS
to verify it was still enabled.) Know any other
settings that could be disabling it? Thanks.
--- Rod Person <[EMAIL PROTECTED]> wrote:
> On Friday 03 March 2006 9:58 pm, David LeCount
> wrote:
> > I recently purchased a Tyan S2895 motherboard and
> more
> > recently a Hitachi SCSI drive. I'm trying like
> hell to
>
> I just got my new workstation 2 days ago with the
> Tyan S2895
> motherboard. Mine is the K8WE with the LSI 1030 U320
> SCSI adapter built in.
> To get this to boot 6.0 I had to do the following.
>
> In the BIOS:
>
> 1. Disable the SLAVE MAC(NIC). Advanced->Integrated
> Devices->Slave Devices
> Menu.
>
> 2. Disable IEEE 1394(firewire). Advanced->PCI
> Configuration->Integrated 1394
> Menu.
>
> With my drive, which was a pull from my old
> workstation, I had kernel built
> that did not have the mpt drive for the LSI adapter
> so during boot I choose
> option 6 and the issused the command:
>
> load mpt
> boot
>
> Then all booted fine.
>
> Although you disable the slave nic (my board has 2
> nics) the primary still
> work as long as you load the if_nve kernel module.
>
> HTH
> --
> Rod Person
>
> http://www.opensourcebeef.net
> http://blog.opensourcebeef.net
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
