Aye, it's got a lot of buttons, and I've tried transferring several of
the config settings, however, none of the drivers they pointed to seem
to exist in BSD, and they also pointed to devices, again nonexistant
in bsd.

example, one involves the following:

Option "Device" "/dev/input/event1"
Option "Protocol" "evdev"


If I try to use evdev, x refuses to start, and says said module does
not exist in the log file. The other variants I've seen have similar
modules that I can't find and won't load.

Thanks,
-Jim



On 3/31/06, Norberto Meijome <[EMAIL PROTECTED]> wrote:
> On Fri, 31 Mar 2006 13:13:49 -0500
> "Jim Stapleton" <[EMAIL PROTECTED]> wrote:
>
> > I've googled the problem in general, tried looking around xorg and
> > this site, but I couldn't find any useful information on getting my
> > MX518 working with all of it's buttons in BSD (were I to downgrade
> > back to Linux, I could, but I'd rather not do that, ports is much more
> > useful than the extra three buttons).
>
>
> Hey Jim
> i suppose this is a logitech mouse with lots of buttons? if you know it
> works with linux, why not transfer the config from linux to freebsd? (u
> dont need to install anything, just try knoppix). It should work out of
> the box (I believe moused is same across platforms, and xorg shouldn't
> worry too much about what OS it's being used under).
>
> otherwise, have u read man moused ?
>
> beto
> _______________________________________________
> freebsd-questions@freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-questions
> To unsubscribe, send any mail to "[EMAIL PROTECTED]"
>
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to