I just installed 6.1 and upgraded to RELEASE-p1. The command dmesg is not displaying any kernel messages, any suggestions? I am running a SCSI hard drive on this box too.

Here is a snipit from the message log in case these issues have anything to do with it.


Timecounter "TSC" frequency 669103956 Hz quality 800
Jun  5 06:55:12 ns2 kernel: Timecounters tick every 1.000 msec
Jun  5 06:55:12 ns2 kernel: Waiting 5 seconds for SCSI devices to settle
Jun 5 06:55:12 ns2 kernel: acd0: CDROM <CREATIVE CD5230E/C1.01> at ata1-master
PIO4
Jun  5 06:55:12 ns2 kernel: da0 at ahc0 bus 0 target 6 lun 0
Jun 5 06:55:12 ns2 kernel: da0: <QUANTUM ATLAS 10K 18WLS UCP0> Fixed Direct Acc
ess SCSI-3 device
Jun 5 06:55:12 ns2 kernel: da0: 160.000MB/s transfers (80.000MHz, offset 31, 16
bit), Tagged Queueing Enabled
Jun 5 06:55:12 ns2 kernel: da0: 17518MB (35877972 512 byte sectors: 255H 63S/T
2233C)
Jun  5 06:55:12 ns2 kernel: Trying to mount root from ufs:/dev/da0s1a
Jun  5 06:55:12 ns2 kernel: dc0: failed to force tx and rx to idle state
Jun  5 06:55:12 ns2 kernel: dc0: failed to force tx and rx to idle state
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to