Ok, it does appear to the be BGE driver, as you suggested. Reinstalled, after resetting the bios, and as long as I don't configure the network interface, it boots and seems happy.
I need a little help, I setup a sup file, and downloaded the sys hiearchy, but I'm not sure which files to copy over to the stock 6.1-RELEASE? In the sys/dev/bge directory there where two files that looked promising, if_bge.c and ifbgereg.h and I copied them over and tried to build a kernel, and it complained about VLAN needing 4 arguements, and only getting 3. I can copy whatever I need to a flash drive and read it on the DL320, so getting the files there is no problem. I've tried pulling the 6.1-CURRENT hiearchy down, and it won't build at all. Can you point me to the updated driver files? Bill "Ted Mittelstaedt" <[EMAIL PROTECTED]> 08/26/06 04:21 AM To <email@example.com>, <[EMAIL PROTECTED]> cc Subject Re: Problems booting HP Proliant DL-320 G4 & 6.1-RELEASE I have one of these running mail right now. Here's what I found: 1) The onboard ethernet chip driver in 6.1-release is buggy and will panic the system. Install and don't enable ethernet. Download the current bge driver from CVS, copy to a floppy, copy from floppy to server, recompile kernel. 2) Turn off the onboard SATA raid in BIOS, it uses adaptec microcode that isn't supported. If you want mirrored raid, there's a procedure that you can do to get it. 3) for some weird reason the system will hang during boot for up to TWO MINUTES. After it gets done doing whatever it's doing, it will continue booting. Install normally, don't do anything special. BIOS settings should be normal. Ted ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <firstname.lastname@example.org> Sent: Friday, August 25, 2006 6:14 PM Subject: Problems booting HP Proliant DL-320 G4 & 6.1-RELEASE > Having problems booting my new 320 G4 after successfully > installing from CD. The CD install went fine, the first boot was > normal, but the second and all subsequent boots hang right > after the WARNING setting entropy source to blocking mode. > > Keyboard is dead and the machine appears locked up. Right > now it's on the screen wanting to enter the seed for SSHD, but > it hangs on even when you don't enable SSHD during install. > > any suggestions? > > I've tried to disable ILo by turning off the Legacy USB support. > FYI, VGA console and regular PS2 keyboard hooked up. > > Any help would be most appreciated. Just bought 4 of these > guys for a project. > > Bill > _______________________________________________ > email@example.com mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "[EMAIL PROTECTED]" > _______________________________________________ firstname.lastname@example.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"