Robert Davison <[EMAIL PROTECTED]> writes:

> After some kind advice from this mail list, im trying to set up an amd 
> automount so that my external hard drive doesnt have to be on all the time 
> for the main server to boot.
>
> My fstab for the drives (there is two drives contained within a Sun StorEdge 
> S1) reads:
>
> /dev/da0s1b        none    swap    sw                0    0
> /dev/da0s1d        /s            none    rw,noauto    0    0
> /dev/da1s1b        none    swap    sw                    0    0    
> /dev/da1s2d        /t            none    rw,noauto    0    0
>
> I've mkdir -p both /s and /t as mount points
>
> I've then put the following lines into /etc/amd.map
>
> localhost/s            type:=program:fs:=/s;\
> mount:="/sbin/mount mount /s";\
> unmount:="/sbin/umount umount /s"
>
> localhost/t            type:=program:fs:=/t;\
>  mount:="/sbin/mount mount /t";\
>  unmount:="/sbin/umount umount /t"
>
> And finaly I've added the following to ,y /etc/rc.conf
>
> portmap_enable="YES"
> amd_enable="YES"
> amd_flags="-a /.amd_mnt -l syslog /host/etc/amd.map"
>
> when i reboot the server the external drives are not mounted.
>
> Am I missing a step here, or the point totally ??

I'm not sure about the exact syntax of what you have, but note that
the automounter won't mount the filesystem until something tries to
access it...
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to