Hi all,

On RELENG_6_2, I'm going to be installing chillisoft from ports.

However, when I first ran 'make', there was an initial configuration
window came up before compile. I selected the wrong options (I realized
this after the make was complete). I did not do a 'make install'.

I tried to 'make clean', distclean then I removed the entire port from
the ports system and re 'supped it and still, when I run make again, the
configuration dialog does not appear.

Am I missing something that I need to remove to put the port back to the
way it was before (so the config dialog will re-appear)?


[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to