Both of those checked OK.  Is it possible I have specified the C/H/S
incorrectly during setup?

Thanks,


Jay

> At 10:49 AM 4/26/2007, [EMAIL PROTECTED] wrote:
>>I have installed FreeBSD 6.2 on an HP Proliant G5 server with an E200i
>>Smart Controller installed.  The installation was flawless.
>>
>>When I reboot the server after the installation, the boot loader screen
>> is
>>displayed.  I press F1 and the system beeps and comes back to the boot
>>loader prompt.
>>
>>What should I be looking at?  I am at a loss since I usually end up with
>>leftover hardware and this time I acutally got to purchase new hardware
>>just for this project.
>>
>>Any suggestions would be greatly appreciated.
>>
>>Thanks for your help.
>
> Check your BIOS that you are ALLOWING the boot sector to be written.
>
> If that is OK, try disabling hyperthreading if that is turned on in your
> BIOS.
>
>          -Derek
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
> MailScanner thanks transtec Computers for their support.
>
>


_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to