Amer H. Alhabsi a écrit :
Philippe Laquet wrote:
Hi Amer,
Could you send an "ifconfig -a" ?
It may occur if your MTU doesn't match
Amer H. Alhabsi a écrit :
Hi,
The network card that came with the PC (Broadcom NetXtreme Gigabit
Ethernet) was not recognized by sysinstall. So I bought a real tek
based card that works fine. But when I run dmesg, I get lots of
these lines (almost 900):
rl0: discard oversize frame (ether type 0 flags 3 len 1532 > max 1514)
Can someone please advise what can be done to stop that.
I'm using FreeBSD 6.2 release.
Thanks,
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to
"[EMAIL PROTECTED]"
Thanks for the reply. Here is the output of "ifconfig -a"
rl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=8<VLAN_MTU>
inet 172.22.15.39 netmask 0xffff0000 broadcast 172.22.255.255
ether 00:e0:4c:ef:04:87
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2
inet6 ::1 prefixlen 128
inet 127.0.0.1 netmask 0xff000000
OK,
You may try to increase your MTU by using "ifconfig rl0 mtu 1580" (for
example) - Do not forget to add this option in /etc/rc.conf (for boot
settings)
If it does not solve the problem, the problem could be due to your
network interface and the "RL" driver itself. In that case, you have to
shut down the interface and remount it, I agree that it is not a proper
solution but I saw it on a newsgroup.
Hope this help!
Kind Regards.
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
