so where, phyisically, on the disk, does the data from make config go
then?  I looked in <port>/. after make clean, and it's as clean as
fresh snow...

Steve

On 10/28/07, Erik Trulsson <[EMAIL PROTECTED]> wrote:
> On Sun, Oct 28, 2007 at 10:13:24AM -0700, Steve Franks wrote:
> > Obviously, 'make clean' doesn't reset the configure screen.  Don't know why.
>
> Because it is not designed to do that.
>
> >
> > I recall there was a faster way to fix this than 'portsnap extract'
> > but I'll be damned if I can remember, and the ports section of the
> > handbook doesn't even mention configure dialogs...
>
> 'make rmconfig' should remove a previously set configuration.
> 'make config' should display the configscreen again if it had already been
> set before.
>
> These are described in the ports(7) manpage (which contains lots of useful
> information regarding the ports system - not least the BUGS section. :-))
>
> >
> > I'd love to add a snippet to the handbook to cover this, but the last
> > time I made an offer like that on [EMAIL PROTECTED], it appears to have gone
> > into dev/null...
> >
>
>
> --
> <Insert your favourite quote here.>
> Erik Trulsson
> [EMAIL PROTECTED]
>


-- 
Steve Franks, KE7BTE
Staff Engineer
La Palma Devices, LLC
http://www.lapalmadevices.com
(520) 312-0089
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to