On Sun, Oct 28, 2007 at 10:41:23AM -0700, Steve Franks wrote:
> so where, phyisically, on the disk, does the data from make config go
> then?  I looked in <port>/. after make clean, and it's as clean as
> fresh snow...

/var/db/ports/

> 
> Steve
> 
> On 10/28/07, Erik Trulsson <[EMAIL PROTECTED]> wrote:
> > On Sun, Oct 28, 2007 at 10:13:24AM -0700, Steve Franks wrote:
> > > Obviously, 'make clean' doesn't reset the configure screen.  Don't know 
> > > why.
> >
> > Because it is not designed to do that.
> >
> > >
> > > I recall there was a faster way to fix this than 'portsnap extract'
> > > but I'll be damned if I can remember, and the ports section of the
> > > handbook doesn't even mention configure dialogs...
> >
> > 'make rmconfig' should remove a previously set configuration.
> > 'make config' should display the configscreen again if it had already been
> > set before.
> >
> > These are described in the ports(7) manpage (which contains lots of useful
> > information regarding the ports system - not least the BUGS section. :-))
> >
> > >
> > > I'd love to add a snippet to the handbook to cover this, but the last
> > > time I made an offer like that on [EMAIL PROTECTED], it appears to have 
> > > gone
> > > into dev/null...
> > >
> >



-- 
<Insert your favourite quote here.>
Erik Trulsson
[EMAIL PROTECTED]
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to