Monah Baki wrote:
Hi all,
I'm trying to install on Freebsd 6.3 plone from ports. I keep geting the
error message
libtool: link: `gscanner.lo' is not a valid libtool object
gmake[4]: *** [libglib.la] Error 1
gmake[4]: Leaving directory
`/usr/ports/devel/pkg-config/work/pkg-config-0.22/glib-1.2.8'
gmake[3]: *** [all-recursive] Error 1
gmake[3]: Leaving directory
`/usr/ports/devel/pkg-config/work/pkg-config-0.22/glib-1.2.8'
gmake[2]: *** [all] Error 2
gmake[2]: Leaving directory
`/usr/ports/devel/pkg-config/work/pkg-config-0.22/glib-1.2.8'
gmake[1]: *** [all-recursive] Error 1
gmake[1]: Leaving directory
`/usr/ports/devel/pkg-config/work/pkg-config-0.22'
gmake: *** [all] Error 2
*** Error code 2
Stop in /usr/ports/devel/pkg-config.
*** Error code 1
Stop in /usr/ports/x11/xproto.
*** Error code 1
Stop in /usr/ports/x11/libXau.
*** Error code 1
Stop in /usr/ports/x11/libX11.
*** Error code 1
Stop in /usr/ports/x11-toolkits/tk84.
*** Error code 1
Stop in /usr/ports/x11-toolkits/py-tkinter.
*** Error code 1
Stop in /usr/ports/graphics/py-imaging.
*** Error code 1
Stop in /usr/ports/graphics/py-imaging.
*** Error code 1
Stop in /usr/ports/www/plone.
This is more a workaround than a solution, but you don't need the X11
libraries to run plone. Try putting "WITHOUT_X11=yes" in your make.conf.
Erik
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
