I have come a bit further. It seems that if I create a 2TB drive it all goes good. But it doesn't seems to work when doing a large 5TB drive. Is there some limitations on fdisk, and the size on partitions? Can't it exceed 2TB? The machine is a ordinary Core 2 duo 6750 with 4GB of ram.
/Regards Goran On Dec 13, 2007 5:39 PM, Göran Nilsson <[EMAIL PROTECTED]> wrote: > On the controller there it says that it supports freebsd 6.1. And yes > there is documentation on how to install freebsd 6.1 on the raid. > But for now i have installed freebsd on a RAID1 system, and i have problem > getting the card detcted, i run a 5TB RAID 6 on this card. > Didn't thought that it could be that much differens between version 6.1and > 6.2. Gonna try to reinstall. After the reinstall i got the card up and > running. I see it get detected and it all looks ok. I go in and do a fdisk > on the drive and label/mount it. I do all this in sysinstall. > I can see that the drive is 4648GB so it all looks ok with the RAID 6 > Drive. > When i later quit sysinstall and check the mounts i see that the drive > space is 532GB and available space is 500GB. This looks totally wrong. Is > there any limitations that im not aware of? > > /Goran > > On Dec 13, 2007 1:10 AM, Erik Trulsson <[EMAIL PROTECTED]> wrote: > > > On Wed, Dec 12, 2007 at 09:35:09PM +0100, Göran Nilsson wrote: > > > Hi, > > > I have a problem getting my EX12350 Radicontroller to work under > > FreeBSD 6.2. > > > When i start the computer or rund a dmesg i can see that > > > "mass storage raid ..no driver attached" > > > For what i can see this card should be supported under FreeBSD 6.1, > > but > > > could it be soo that the support is missing in 6.2? Any tips? > > > Should i try to go for the 6.3 RC1. I really need this card up and > > running, > > > i run it as a RAID 6. I have tried this with just the generic kernel, > > > So the most should be in there? > > > > > > Ideas, is most appriciating, coz im kinda stuck. > > > > > > > > > What makes you think this card is supported by FreeBSD 6.1? > > > > As far as I can tell there is no driver for that card included with any > > FreeBSD release. If it was supported the driver would have been > > included in > > GENERIC kernel, and if was supported in 6.1 it would have been in 6.2also. > > > > > > It is quite possible however that Promise provides their own FreeBSD > > driver > > for that card. If that is the case you should ask Promise which > > version(s) > > of FreeBSD the driver supports and how to install it - or read their > > documentation where such information can likely be found. > > > > > > > > > > -- > > <Insert your favourite quote here.> > > Erik Trulsson > > [EMAIL PROTECTED] > > > > _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"