Nuno Gonçalves wrote:
I am trying to do a Bare Metal Recovery from a FreeBSD 6.0 system to a
I have a backup from all partitions of the affected system so I am trying to
install a minimum FreeBSD 6.0 in a different hardware which I already have
up and running.
What kind of backup? Is it a dump(8) file?
I created a Swap Partition, a “/” partition where the minimum system is
running, and a third partition “/backup” in which I will restore the backup
through the network.
Next step will be to change the boot manager and make it boot through
Do you guys think this is doable?
I Think I probably must recompile the kernel after the bare metal recovery
because the hardware is different, still do you think it might work?
Did the kernel have a lot of customization? A GENERIC kernel should
boot on almost anything --- which is why "bare metal recovery" seems
a misnomer to me. If the hard disk survives, I simply stick it in
another box and rarely have any difficulties. If it doesn't, I do
a minimal install with the desired final slice/partition scheme on
the new HDD, and simply restore(8) over the top.
What is your opinion on this? What should be the best approach ?
Well, I don't know your exact situation, but OOTOMH, the partitioning
scheme you mention seems like wasting a disk unless you want the
final system to have only /, swap, and /backup. Which could be
OK, I guess, but isn't the traditional BSD Right Way(tm).
Also, I'd consider installing a newer release than 6.0, and only
restoring the important stuff. Again, it depends on your situation.
You have been in Afghanistan, I perceive.
-- Sherlock Holmes, A Study in Scarlet
firstname.lastname@example.org mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"