On Fri, May 23, 2008 at 10:12:17PM -0700, paul beard wrote:
> On Fri, May 23, 2008 at 2:08 PM, Kris Kennaway <[EMAIL PROTECTED]> wrote:
> 
> >
> > You can try increasing the timeout by editing the relevant kernel
> > source, but if it's failing to reply to the I/O after 30 seconds then
> > something is drastically overloaded on your system.
> 
> 
> Well, not much is running, and I have recently built a new kernel and
> world in less time than it takes to get this one port upgraded. I
> think there is something else amiss. Should this really be soaking up
> 100Mb of RAM?

Yes, that is quite normal.

> PID      USERNAME       THR PRI NICE   SIZE    RES STATE    TIME   WCPU 
> COMMAND
> 32272   root                      1   -20    0         101M   70340K
> swread   3:04  0.93%   cc1
> 
> 
> I have filed a bug against gcc, per instructions. There seems to be an
> issue somewhere in py-gtk that is exacerbated by the low resources on
> this system.

There is no bug in gcc.  Your system does not have enough memory to
run the compilation job, so you are thrashing it severely.  Try
turning down the CFLAGS optimization level, or use a precompiled
package from the FTP site or built on another machine.

Kris
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to