Hello all there!...

Once i would like to enable disk encryption with geli approcah, i noticed following problem:



CASE 1 | SUCCES
-----------------------------------------------------------------------------------------------
geli init -b -e aes -l 256 -s 4096 /dev/ad4s1
This initializes geli without problem, and then once you run 'bsdlabel -w /dev/ad4s1' it goes as expected. CASE 2 | FAIL
-----------------------------------------------------------------------------------------------
geli init -b -e aes -l 256 -s 8192 /dev/ad4s1
This initializes geli with a warning message 'sector size is bigger than the page size' and also 'bsdlabel -w /dev/ad4s1' fails with following notice: 'bsdlabel: /dev/ad4s1 read: invalid argument' CASE 3 | FAIL
-----------------------------------------------------------------------------------------------
geli init -b -e aes -l 256 -s 4096 -a hmac/sha256 /dev/ad4s1
This initializes geli with a warning message 'sector size is bigger than the page size' and also 'bsdlabel -w /dev/ad4s1' fails with following notice: 'bsdlabel: /dev/ad4s1 read: invalid argument' In short, if i enable 'data integrity verification' or if i increase 'sector size', 'bsdlabel -w' gives error message.



I thank you in advance for advises.


Regards,
Cem
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to