Kevin, As the problem only occurs after I exit X the log file isn't very helpful as to what happens after. The last line is
(II) Mouse0: SetupAuto: protocol is SysMouse However it seems to be cycling through various resolution modes before starting, but no errors/warnings except for these lines (II) VESA(0): Total Memory: 495 64KB banks (31680kB) (II) VESA(0): Monitor0: Using hsync range of 30.00-62.00 kHz (II) VESA(0): Monitor0: Using vrefresh range of 55.00-75.00 Hz (II) VESA(0): Monitor0: Using maximum pixel clock of 100.00 MHz (WW) VESA(0): Unable to estimate virtual size (II) VESA(0): VESA BIOS detected (II) VESA(0): VESA VBE Version 3.0 (II) VESA(0): VESA VBE Total Mem: 31680 kB (II) VESA(0): VESA VBE OEM: S3 Graphics ProSavage DDR Family BIOS (II) VESA(0): VESA VBE OEM Software Rev: 2.0 (II) VESA(0): VESA VBE OEM Vendor: S3 Garphics Incorporated. (II) VESA(0): VESA VBE OEM Product: VBE 3.0 (II) VESA(0): VESA VBE OEM Product Rev: Rev 0.0 (WW) VESA(0): Failed to set write-combining range (0xe0000000,0x1ef0000) (II) VESA(0): virtual address = 0x28964000, physical address = 0xe0000000, size = 32440320 (==) VESA(0): Write-combining range (0x0,0x1000) was already clear This last line is repeated about 200 times throughtout the file. Glen, It is an onboard graphics, some sort of VIA chipset. scanpci gives this pci bus 0x0000 cardnum 0x00 function 0x00: vendor 0x1106 device 0x3116 VIA Technologies, Inc. VT8375 [KM266/KL266] Host Bridge pci bus 0x0000 cardnum 0x01 function 0x00: vendor 0x1106 device 0xb091 VIA Technologies, Inc. VT8633 [Apollo Pro266 AGP] pci bus 0x0000 cardnum 0x11 function 0x00: vendor 0x1106 device 0x3177 VIA Technologies, Inc. VT8235 ISA Bridge pci bus 0x0001 cardnum 0x00 function 0x00: vendor 0x5333 device 0x8d04 S3 Inc. VT8375 [ProSavage8 KM266/KL266] I use the default install and I don't know what driver to get or how to build it.. but surely if you have the wrong drivers X will not start rather than not stop? Any suggestions? Herman On Fri, Sep 26, 2008 at 4:53 AM, Kevin Kinsey <[EMAIL PROTECTED]> wrote: > Have you looked at the logfiles? (/var/log/Xorg.$n.log) > > > Kevin Kinsey > -- > Let your conscience be your guide. > -- Pope > _______________________________________________ email@example.com mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"