"Davenport, Steve M" <[EMAIL PROTECTED]> writes: > Hello, > > I am running snmpd 220.127.116.11 built from a port on 7-Release, hardware is > Sun V100, 512Mb total memory, 381Mb free. The daemon starts fine. When a > snmpwalk is done from another system all is well until the interface > table and then I see: > > interfaces.ifTable.ifEntry.ifSpeed.1 : Gauge32: 10000000 > interfaces.ifTable.ifEntry.ifSpeed.2 : Gauge32: 0 > interfaces.ifTable.ifEntry.ifSpeed.3 : Gauge32: 0 > snmpwalk: No response arrived before timeout. > > After the timeout happens, looking at "swapinfo -k" shows that swap > space is continually consumed until empty at which point the snmpd > daemon is stopped: > > fbsdh# swap_pager: out of swap space > swap_pager_getswapspace(16): failed > Nov 25 11:44:08 fbsdh kernel: pid 84674 (snmpd), uid 0, was killed: out > of swap space > > Now the swap space is freeded: > fbsdh# swapinfo -k > Device 1K-blocks Used Avail Capacity > /dev/ad0b 2099160 26456 2072704 1% > > Has anyone seen this issue or know of a solution.
Since you're running the SNMP daemon from a port, not the one from the base system, you may need developers' assistance for this sort of bug. Problems like this are often caused by wraparound bugs or infinite loops in my experience, although there are lots of other possibilities. If you can get a stack traceback when it crashes, that will is quite likely to give a solid clue. -- Lowell Gilbert, embedded/networking software engineer, Boston area http://be-well.ilk.org/~lowell/ _______________________________________________ email@example.com mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"