>> freebsd 7.1 >> >> Dell 2900, perc 6/i controller with 4 SATA disks in RAID1. >> >> We get all the through the disc1 install, reboot, >> >> arrive up to >> >> "Press <ctrl-E> for remote access setup within 5 secs ...." >> >> then die with >> >> "Invalid partition table" >> >> We had RAID5, same problem, switch to RAID1. >> >> suggestions? > >Is your BIOS set to boot from the right device - the raid and >not the one of the disks in it??? >
Boot sequence says "1. drive c:" controller disk setup shows RAID1 ready. I've looked everywhere to see if I can point the boot at RAID1. Thanks, Len _______________________________________________ email@example.com mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"