Joerg Pulz ha scritto:

If i remeber correctly, you have to enable the RAID option in the BIOS to configure the two disk as array, afterwards you must enter the BIOS again and switch to AHCI. As the ataraid driver detects the array by reading the metadata on the disks it should detect the array. I'm not 100 percent sure but i think this is the way i did it.

pciconf -lv show the following for the atapci device (again there is AHCI mentioned in the output):
- ----
atap...@pci0:0:31:1: class=0x01018a card=0x10a51734 chip=0x27df8086 rev=0x01 hdr=0x00
    vendor     = 'Intel Corporation'
    device     = '82801G (ICH7 Family) Ultra ATA Storage Controller'
    class      = mass storage
    subclass   = ATA
atap...@pci0:0:31:2: class=0x010601 card=0x10a51734 chip=0x27c18086 rev=0x01 hdr=0x00
    vendor     = 'Intel Corporation'
    device     = '82801GB I/O Controller Hub SATA cc=AHCI'
    class      = mass storage
- ----

Same output here, but changing the BIOS settings did not help.
The only way I found to get it working was to build the mirror through atacontrol.

 bye & Thanks
_______________________________________________ mailing list
To unsubscribe, send any mail to ""

Reply via email to