To top off my confusion when I boot I'm getting different dev/vendor id's from the card than are mentioned in the post referenced above.
Here's my dmesg output:
pcib0: <Intel 82845 Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82845 PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <NVidia Riva Ultra Vanta TNT2 graphics accelerator> at 0.0 irq 11
pcib2: <Intel 82801BA/BAM (ICH2) Hub to PCI bridge> at device 30.0 on pci0
pci3: <PCI bus> on pcib2
pci3: <unknown card> (vendor=0x14e4, dev=0x4301) at 2.0 irq 11
xl0: <3Com 3c905C-TX Fast Etherlink XL> port 0xac00-0xac7f mem 0xdfefdf80-0xdfefdfff irq 10
at device 5.0 on pci3
xl0: Ethernet address: 00:01:03:de:12:db
miibus0: <MII bus> on xl0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
The linksys WMP11 is listed as pci3. Note that the vendor/dev ids are different from those listed in the patch posted by Thomas Skibo <[EMAIL PROTECTED]> to freebsd-mobile (as referenced above) which shows the device as:
+ {0x1260, 0x3873, WI_BUS_PCI_NATIVE, "Linksys WMP11 PCI Prism2.5"},
So, the qeustion is, can I make this (actually these 10) cards work with FreeBSD? Any help or pointers on this would be greatly appreciated.
--Aaron
To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-questions" in the body of the message