On Wed, Apr 27, 2011 at 10:42 AM, Jaime Kikpole <jkikp...@cairodurham.org> wrote: > My thanks to everyone for their replies. I guess that I wasn't > specific enough about my needs, though. I don't need a tiny chassis. > In fact, I need a proxy for around 750-900 computers, so an Atom > system or the like wouldn't work for me. I just have no rack space > left. Fortunately, I might have found a way around this. > > So if you have any pre-built servers to recommend, I'd greatly > appreciate it. For example, I'm currently reviewing the Dell > PowerEdge T310's specs. > > > Nate: > > Thanks. I read the handbook's entry on CARP last night. It looks > easier than I had previously thought. I've started setting up a > VMware environment of 2 FreeBSD systems and a unix desktop to try it > out as a way to build a fail-over proxy. > > Looks like I'd have to stop using my current "in-line" design, though. > Currently, I have a FreeBSD box between my network as a whole and the > Internet connection. It acts as a router, a firewall, and a > transparent proxy. CARP would require the system to not be "in-line," > because a failed system would mean no router. Did I understand that > correctly? > > > Thanks to all, > Jaime > > -- > Network Administrator > Cairo-Durham Central School District > http://cns.cairodurham.org >
Actually - quite the opposite. I have a very similar setup, wherein I have two machines running CARP on multiple interfaces such that if any interface on system A goes down, system B takes over. Both of these machines act in the same capacity as yours, (they are router+firewall+proxy+NAT), they are physically cabled directly to my network switches using VLAN trunking which presents as-if multiple separate network cards on the host (they each have gigabit fibre to the switch, carrying 8 independent networks). Each subnet (separate VLAN segment) routes their primary gateway through these machines using a single IP - both are always on, always running, and each is connected to a different core switch (which offers switching redundancy too in the event one goes out). I'm using mostly Cisco networking gear, but all routing and proxying is done by FreeBSD/sparc on Sun Netra series servers. As far as your hadrware is concerned - I'm a bit biased towards Sun or Dell, though I've also had great experience with Compaq (now HP) Proliant series in the passed too. Again - same deal as white-boxes, just check the hardware list to see what's supported. When you've got an actual make/model you're thinking of, re-post a new thread to questi...@freebsd.org with a subject as such seeking opinions and experiences with that model - chances are someone else might already have it. (I did take note of the Dell model you specified - just saying might be a good idea to put that as the subject in a new thread; sorry no experience with that model personally, though I have several 2800-series Dell 2U servers that I'm most pleased with offering redundant power and decent hardware raid). -- Nathan Vidican nat...@vidican.com _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"