Here is the dmesg if it could help!

Francisco Gómez Marín wrote:


I have bought an intel dot-station. It has an USB keyboard with a touchpad on it. The keyboard works but the touchpad doesn't work with a typic USB mouse configuration, nor in console (moused -p /dev/ums0 -t auto) nor in X.
I have googled and searched in the archives of the list without success.
Is this type of touchpad supported? what can I do?

[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.1-CURRENT #1: Fri Aug  1 02:26:22 CEST 2003
    [EMAIL PROTECTED]:/usr/src/sys/i386/compile/AOL
Preloaded elf kernel "/boot/kernel/kernel" at 0xc04a1000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc04a1244.
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 299092604 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (299.09-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x665  Stepping = 5
real memory  = 65798144 (62 MB)
avail memory = 58859520 (56 MB)
pnpbios: Bad PnP BIOS data checksum
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <MNTRAL MO81010A> on motherboard
pcibios: BIOS version 2.10
Using $PIR table, 7 entries at 0xc00f40c0
acpi0: power button is handled as a fixed feature programming model.
Timecounter "ACPI-safe"  frequency 3579545 Hz
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x408-0x40b on acpi0
acpi_cpu0: <CPU> port 0x530-0x537 on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pcib0: slot 1 INTA is routed to irq 11
pcib0: slot 31 INTD is routed to irq 9
pcib0: slot 31 INTB is routed to irq 6
agp0: <Intel 82810 (i810 GMCH) SVGA controller> mem 
0xffa80000-0xffafffff,0xf8000000-0xfbffffff irq 11 at device 1.0 on pci0
pcib1: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci1: <ACPI PCI bus> on pcib1
pcib1: slot 1 INTA is routed to irq 10
pcib1: slot 7 INTA is routed to irq 10
pcib1: slot 9 INTA is routed to irq 11
fxp0: <Intel 82557/8/9 EtherExpress Pro/100(B) Ethernet> port 0xdd80-0xddbf mem 
0xff700000-0xff7fffff,0xff8ff000-0xff8fffff irq 10 at device 1.0 on pci1
fxp0: Ethernet address 00:03:47:3f:2e:55
miibus0: <MII bus> on fxp0
inphy0: <i82555 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pcm0: <AudioPCI ES1373-8> port 0xde80-0xdebf irq 10 at device 7.0 on pci1
pcm0: <Cirrus Logic CS4297A AC97 Codec>
pci1: <simple comms> at device 9.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH UDMA66 controller> port 0xffa0-0xffaf at device 31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82801AA (ICH) USB controller> port 0xef80-0xef9f irq 9 at device 31.2 on 
usb0: <Intel 82801AA (ICH) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhub1: Texas Instruments TUSB2046 hub, class 9/0, rev 1.10/1.25, addr 2
uhub1: 4 ports with 4 removable, self powered
ukbd0: FORWARD USB Multimedia Keyboard, rev 1.10/1.01, addr 3, iclass 3/1
kbd0 at ukbd0
ums0: FORWARD USB Multimedia Keyboard, rev 1.10/1.01, addr 3, iclass 3/1
ums0: 3 buttons and Z dir.
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
orm0: <Option ROMs> at iomem 0xc8000-0xc8fff,0xc0000-0xc7fff on isa0
pmtimer0 on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 10.000 msec
ad0: DMA limited to UDMA33, non-ATA66 cable or device
ad0: 4126MB <ST34313A> [8944/15/63] at ata0-master UDMA33
Mounting root from ufs:/dev/ad0s1a
[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to