Richard Shea wrote:
After editing /etc/mail/access, run 'makemap hash /etc/mail/access <
/etc/mail/access' to rebuild the access db and then restart sendmail.
Thanks to both of you for your replies however this has raised another
question ! ... (see below)
On Mon, 11 Aug 2003 13:16:54 +0200, "Roger 'Rocky' Vetterberg"
<[EMAIL PROTECTED]> said:
Konrad Heuer wrote:[Original Question snipped]
On Mon, 11 Aug 2003, Richard Shea wrote:
Yes, sendmail_enable="YES" will do the job.Checkout /etc/mail/access, it allows you to control who is permitted to
relay trough your server.
FreeBSD sendmail respects the TCP wrapper config file /etc/hosts.allow;
you can limit access to sendmail there (look at "man 5 hosts_options").
Well I discovered I think that if I don't use /etc/mail/access in fact I
cannot send mail through the FBSD box. (I get "550 5.7.1 ... Relaying
denied"). So I went an looked at /etc/mail and there is a access.sample
but not a plain access file so I copied and edited access.sample to
include a line ...
... and rebooted but still I get the same error. On the system console I
get a more verbose form of the same message but also "lost input channel
from SS11232 [192.168.10.4] to MTA after rcpt" which doesn't sound too
good to me.
Am I using the access file correctly here ? Am I right in thinking that I
MUST use the access file or could I just ignore it ? Should I have
renamed access.sample to access ?
Thanks again for your help so far and any other help would be welcome.
[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"