On Sun, Sep 28, 2003 at 07:41:04AM -0400, nw1 wrote:
> Neither mouse will work in the console or in XFree86.
> Gigabyte GA-6BXDS = main board
> BIOS= AWARD (2A69KG01) ver. 4.51PG
> In the PCI/ISA section of the BIOS, a USB setting of: "Assign IRQ For USB: Enabled"
> There is also a "USB Keyboard Support" setting within the BIOS's "INTERGRATED
> PEROPHERALS" section; I have tried this setting to both "Enabled and Disabled".
> There aren't any other USB settings in this BIOS.
> We are using these devices that are known working devices.
> Mouse-1 is: Logitech | model: M-BD58 | optical corded wheel
> Mouse-2 is: Logitech | model: M-RM67A | Optical cordless wheel
> Our Kernel:
> # USB support
> device uhci # UHCI PCI->USB interface
> device usb # USB Bus (required)
> device ums # Mouse
> pseudo-device ether # Ethernet support
> Our /etc/rc.conf:
> # grep -i mouse /etc/rc.conf
> # grep -i usb /etc/rc.conf
> Our /dev:
> ls -l /dev | grep -i ums
> crw-rw---- 1 root operator 111, 0 Sep 27 13:16 ums0
> dmesg reports:
> # dmesg | grep -i usb
> uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xa000-0xa01f irq 10 at device
> on pci0
> usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
> usb0: USB revision 1.0
> ums0: Logitech USB Mouse, rev 1.10/6.10, addr 2, iclass 3/1
> Upon booting into the OS, using the above BIOS, and other settings --with either of
> above devices; the mouse is seen on screen, but it refuse to respond while moving the
> hand-held device. Should we unplug one mouse (from either usb port) to test the
> mouse, we receive the following on-screen message(s), respectively of the
> motherboards USB
> port we were using:
> uhub0: device problem, disabling port 2
> uhub0: device problem, disabling port 1
> When we plug the devices back in to either of the motherboards mouse ports, there's
> indication at all, from the OS, that a USB device was attached.
> Reminder: these devices are in perfect working order.
It seems to be in order. As i see it thare are two posibilties. 1) Your
mouse isn't supported or 2) There is a (new) bug in the system.
Did it work on previous version of FreeBSD?
Articles based on solutions that I use:
[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"