Alex: please see the update/corrections to this post at http://69.3.136.141/freebsd/usb_mouse.txt
----- Original Message ----- From: "Alex de Kruijff" <[EMAIL PROTECTED]> To: "nw1" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Sunday, September 28, 2003 1:44 PM Subject: Re: FreeBSD 4.8-P10 --Mouse doesn't move in the console or XFree86-- > On Sun, Sep 28, 2003 at 07:41:04AM -0400, nw1 wrote: > > Neither mouse will work in the console or in XFree86. > > > > Gigabyte GA-6BXDS = main board > > BIOS= AWARD (2A69KG01) ver. 4.51PG > > > > In the PCI/ISA section of the BIOS, a USB setting of: "Assign IRQ For USB: Enabled" (is > > set) > > There is also a "USB Keyboard Support" setting within the BIOS's "INTERGRATED > > PEROPHERALS" section; I have tried this setting to both "Enabled and Disabled". > > > > There aren't any other USB settings in this BIOS. > > > > We are using these devices that are known working devices. > > Mouse-1 is: Logitech | model: M-BD58 | optical corded wheel > > Mouse-2 is: Logitech | model: M-RM67A | Optical cordless wheel > > > > Our Kernel: > > # USB support > > device uhci # UHCI PCI->USB interface > > device usb # USB Bus (required) > > device ums # Mouse > > pseudo-device ether # Ethernet support > > > > Our /etc/rc.conf: > > # grep -i mouse /etc/rc.conf > > moused_enable="YES" > > moused_port="/dev/ums0" > > # grep -i usb /etc/rc.conf > > usbd_enable="YES" > > > > Our /dev: > > ls -l /dev | grep -i ums > > crw-rw---- 1 root operator 111, 0 Sep 27 13:16 ums0 > > > > dmesg reports: > > # dmesg | grep -i usb > > uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xa000-0xa01f irq 10 at > > device 7.2 > > on pci0 > > usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 > > usb0: USB revision 1.0 > > ums0: Logitech USB Mouse, rev 1.10/6.10, addr 2, iclass 3/1 > > > > Upon booting into the OS, using the above BIOS, and other settings --with either of the > > above devices; the mouse is seen on screen, but it refuse to respond while moving > > the > > hand-held device. Should we unplug one mouse (from either usb port) to test the > > other > > mouse, we receive the following on-screen message(s), respectively of the > > motherboards USB > > port we were using: > > > > uhub0: device problem, disabling port 2 > > uhub0: device problem, disabling port 1 > > > > When we plug the devices back in to either of the motherboards mouse ports, > > there's no > > indication at all, from the OS, that a USB device was attached. > > > > Reminder: these devices are in perfect working order. > > It seems to be in order. As i see it thare are two posibilties. 1) Your > mouse isn't supported or 2) There is a (new) bug in the system. > > Did it work on previous version of FreeBSD? > > -- > Alex > > Articles based on solutions that I use: > http://www.kruijff.org/alex/index.php?dir=docs/FreeBSD/ > _______________________________________________ > [EMAIL PROTECTED] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "[EMAIL PROTECTED]" > _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
