> > Hi, > > I am haviing the worst time trying to install FreeBSD > on a HP Pavilion 8670C.It has ATAPI CD-ROMS > and when I attempted to do an installation > of FreeBSD with version 4.7 of the software > it failed. I attempted to do an installation from a > MS-DOS partition and thatb also failed. > The softwae error message was that it couldnot swap > to the swap space I created for it through Partition magic.
I don't understand why you are trying to create a separate slice for swap with Partition Magic. Maybe you are confusing the concepts of slice and partition - which is easy to confuse since Microsloth uses the terms differently from BSD UNIX namely FreeBSD. The major divisions you create with Partition Magic are called slices in FreeBSD but called partitions in MSland. If the FreeBSD world, you forther divide slices in to partitions named a-h. One of those [sub]divisions - normally 'b' is reserved for swap. Even if you decided to make a separate slice to be used for swap, you would need to furtner "divide" it in to at least one partition (again probably labeled 'b') that could be designated as swap. The system does not access slices per se for any normally addresses activity such as file space or swap. So, with Partition Magic you create a slice for MS-DOS and one for FreeBSD (up to four different slices if you want/need). Probably slice 1 will be MS and slice 2 (or maybe 4 is common) will be designated for FreeBSD. I'll assume you have managed to get the MS stuff in the MS slice. Then you do the install in to the other (FreeBSD) slice. when you do the install, you divide up that FreeBSD slice in to separate partitions. You can do then on by hand yourself on a disk if you already have FreeBSD running by using first 'fdisk' and then 'disklabel. Fdisk creates the major divisions called slices (and maniputates the Master Boot Record [MBR] which allows you to select between bootable slices). Disklabel creates the subdivisions called partitions (and manipulates the boot blocks in bootable slices). The installation utility (/stand/sysinstall) does all that for you with a sort-of-gui-ish interface. It collects the information for the slices and runs fdisk and then the information for partitions and runs disklabel. Anyway, don't try to create a 'slice' for swap. Use the 'b' partition within the FreeBSD slice. ////jerry > Please if there is any help you van offer me I will > sinserly appreciae it. I am almost at the end > with FreeBSD. I have been trying for nearly a > month. I had no troble with my Dell but the Hewlett > Packard has been giving me trouble.. > > Thank you > > Andrew Hillard > > [EMAIL PROTECTED] > _______________________________________________ > [EMAIL PROTECTED] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "[EMAIL PROTECTED]" > > _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"