Problem found. Update posted to: http://188.8.131.52/freebsd/usb_mouse.txt
This case/instance is considered closed; --bum chipset/hardware to blame. ------------------------------------- All incoming attachments get deleted. Have a nice day. ------------------------------------- ----- Original Message ----- From: "nw1" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Sunday, September 28, 2003 12:51 PM Subject: Re: FreeBSD 4.8-P10 --Mouse doesn't move in the console or XFree86-- > Alex: please see the update/corrections to this post at > http://184.108.40.206/freebsd/usb_mouse.txt > > ----- Original Message ----- > From: "Alex de Kruijff" <[EMAIL PROTECTED]> > To: "nw1" <[EMAIL PROTECTED]> > Cc: <[EMAIL PROTECTED]> > Sent: Sunday, September 28, 2003 1:44 PM > Subject: Re: FreeBSD 4.8-P10 --Mouse doesn't move in the console or XFree86-- > > > > On Sun, Sep 28, 2003 at 07:41:04AM -0400, nw1 wrote: > > > Neither mouse will work in the console or in XFree86. > > > > > > Gigabyte GA-6BXDS = main board > > > BIOS= AWARD (2A69KG01) ver. 4.51PG > > > > > > In the PCI/ISA section of the BIOS, a USB setting of: "Assign IRQ For USB: > > > Enabled" > (is > > > set) > > > There is also a "USB Keyboard Support" setting within the BIOS's "INTERGRATED > > > PEROPHERALS" section; I have tried this setting to both "Enabled and Disabled". > > > > > > There aren't any other USB settings in this BIOS. > > > > > > We are using these devices that are known working devices. > > > Mouse-1 is: Logitech | model: M-BD58 | optical corded wheel > > > Mouse-2 is: Logitech | model: M-RM67A | Optical cordless wheel > > > > > > Our Kernel: > > > # USB support > > > device uhci # UHCI PCI->USB interface > > > device usb # USB Bus (required) > > > device ums # Mouse > > > pseudo-device ether # Ethernet support > > > > > > Our /etc/rc.conf: > > > # grep -i mouse /etc/rc.conf > > > moused_enable="YES" > > > moused_port="/dev/ums0" > > > # grep -i usb /etc/rc.conf > > > usbd_enable="YES" > > > > > > Our /dev: > > > ls -l /dev | grep -i ums > > > crw-rw---- 1 root operator 111, 0 Sep 27 13:16 ums0 > > > > > > dmesg reports: > > > # dmesg | grep -i usb > > > uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xa000-0xa01f irq 10 at > > > device > 7.2 > > > on pci0 > > > usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 > > > usb0: USB revision 1.0 > > > ums0: Logitech USB Mouse, rev 1.10/6.10, addr 2, iclass 3/1 > > > > > > Upon booting into the OS, using the above BIOS, and other settings --with either > > > of > the > > > above devices; the mouse is seen on screen, but it refuse to respond while moving the > > > hand-held device. Should we unplug one mouse (from either usb port) to test the other > > > mouse, we receive the following on-screen message(s), respectively of the motherboards > USB > > > port we were using: > > > > > > uhub0: device problem, disabling port 2 > > > uhub0: device problem, disabling port 1 > > > > > > When we plug the devices back in to either of the motherboards mouse ports, > > > there's no > > > indication at all, from the OS, that a USB device was attached. > > > > > > Reminder: these devices are in perfect working order. > > > > It seems to be in order. As i see it thare are two posibilties. 1) Your > > mouse isn't supported or 2) There is a (new) bug in the system. > > > > Did it work on previous version of FreeBSD? > > > > -- > > Alex > > > > Articles based on solutions that I use: > > http://www.kruijff.org/alex/index.php?dir=docs/FreeBSD/ > > _______________________________________________ > > [EMAIL PROTECTED] mailing list > > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > > To unsubscribe, send any mail to "[EMAIL PROTECTED]" > > > _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"