I habitually put
in /boot/loader.conf because I'm impatient. It doesn't stop me from booting
into single-user mode - you just have to hit a key while loader(8) is
spinning, before it starts the kernel.
As far as I can tell, the options in /boot.config apply to boot2, which has
its own command prompt. I occasionally interrupt that one by mistake, and
get confused because it's nothing like loader.
So if you want to tie down the boot process, you will probably need to use
----- Original Message -----
From: "Dru" <[EMAIL PROTECTED]>
Subject: Re: protecting loader
> On Thu, 4 Dec 2003, Nathan Kinkade wrote:
> > On Thu, Dec 04, 2003 at 02:20:07PM -0500, Dru wrote:
> > >
> > > Is there a way to prevent a user from bypassing loader and
> > > loading/unloading stuff at the OK prompt? (other than physical
> > > measures)
> > >
> > > I tried placing "/boot/loader -n" in "/boot.config", but it didn't
> > > difference.
> > >
> > > Dru
> > If I understand your question, you could put the following line in your
> > /boot/loader.conf file:
> > autoboot_delay="0"
> > I think this will effectively prevent users from interrupting the loader
> > to make changes. Just make sure that you have some other way to boot
> > the system, such as a floppy, in case you later run into problems.
> > Nathan
> > --
> > gpg --keyserver pgp.mit.edu --recv-keys D8527E49
> Actually, I discovered that "password=somevalue" in /boot/loader.conf
> filled the bill quite nicely :-)
> [EMAIL PROTECTED] mailing list
> To unsubscribe, send any mail to
[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"