The info on hw.physmem in this thread mostly did the trick for me:

Setting hw.physmem was the first part of the puzzle. However, as was one of the thread participants, I was getting a fatal trap 12 when I enabled APIC. Just so I could tell myself I'd tried everything, I changed the APIC mode from "Full Table Mapped" (I had had 4.7 installed and running properly set that way) to "Full Table". To my surprise, it worked beautifully!

Compaq Proliant 1500 (E12)
Dual P-133
SMART Array Controller firmware revision 2.26
5 4.3GB SCSI drives
[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to