> Hi Everybody , > > I want to install FreeBSD 4.9 or 4.9 but after installation finished > then system try to boot again after reset but it's delayed on this > sentence. > > > ** > Agp0: <AMD 762 host to AGP bridge> mem > 0xf4300000-0xf4300ffff,0xf8000000-0xfbffffff id device 0.0 on pci0 > **
But is it really a problem? Do you experience stability problems or anything? If not, then I guess it's not really much of a problem. And what is the time of the delay? My FreeBSD 5.1-RELEASE hangs a bit during the detection of my IDE controller, but it's rock-solid. I guess you shouldn't worry too much about it unless it gives serious problems. > it's interesting, I'm installed 4.9 and 4.8 via Floppy drive then I try to > install FreeBSD 5.1 and 5.2 because I think that maybe unsupported drive > it's delayed on same place ( I can't see the sysinstall menu ) ?!?!?! > I don't understand why I can pass this section via floppy ?! Umm...I seriously don't understand anything of this sentence > > I checked http://www.freebsd.org/releases/4.9R/hardware-i386.html#AEN16 > page > but I can't find any informaiton that my board supported or not ?! > > > Any idea ?! > > Vahric MUHTARYAN > > _______________________________________________ > [EMAIL PROTECTED] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to > "[EMAIL PROTECTED]" > _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"