"Rajamani, Rajarajan (Rajarajan)" <[EMAIL PROTECTED]> writes:
> I am running 5.1-RELEASE on a DELL GX150 with 512MB RAM on which I installed a new > WD-1600JB IDE along > with the promise UDMA100 controller which came along with the drive. The drive can > be accessed > but the access speed is very slow and I noticed that dmesg shows the following > ad4: UDMA ICRC error cmd=read fsbn 0 of 0-3 retrying > This repeats and is followed by > ad4: UDMA ICRC error cmd=read fsbn 0 of 0-3 falling back to PIO mode > > I have changed the PCI slot on which the card is seated, changed cables and even > hooked > the drive directly to the mother board but the problem persists. > The disc+controller however works ok on a wintel machine. Could it be some type of > hard disc error ? Possible, but not terribly likely. [Unless it's actually running in PIO mode on Windows also.] Does the same occur on FreeBSD 5.2 or 4.9? _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"