I'm setting up a router/firewall to measure bandwidth on our co-located customers and
when i try to configure the second eth card with a new ip adress but the same details
as the first card(except that it has it's own ip)with the /stand/sysinstall utility i
get an error when i press ok, it says.
Invalid gateway IPv4 address specified
All the settings are the same except the ipv4 address which is one d-class higher then
the first eth card.
Med vänliga hälsningar / With kind regards
Stefan Midjich, Swebase AB
Tel: 042-20 15 00
Fax: 042-20 15 03
E-post: [EMAIL PROTECTED]
[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"