On 2/25/2004 at 3:11 PM Henning, Brian wrote: |ntpq -c peer | | remote refid st t when poll reach delay offset |jitter |======================================================================== |====== |+time.nist.gov .ACTS. 1 u 26 64 377 51.856 -41.364 |20.284 |*timekeeper.isi. .GPS. 1 u 27 64 377 64.875 -25.463 |20.041 | |I am assuming this is what you mean. |It looks like it is working. =============
That's working fine. ntp takes some time to fully "discipline" your local clock. You may even see "synchronization lost" messages in your log file for up to a week. The ntp.drift file takes up to a couple of hours to appear. The "unparsable" message is OK for new instances of the ntp.drift file. I usually install ntpd, then touch the ntp.drift file. So long as the "reach" column shows 377, you are synch'd up and working. The "reach" column starts at 1 and counts up to 377. One suggestion, though. Do not use stratum 1 servers as your source, they are over-busy. Use stratum 2 servers instead. Look here for some guidance on this topic: http://www.eecis.udel.edu/~mills/ntp/servers.html _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"