Thanks for your reply. I noticed that your firewire drive is found during boot:On Thu, 01 Apr 2004 15:12:35 -0800 Drew Tomlinson <[EMAIL PROTECTED]> wrote:
I'm using 4.9-RELEASE-p4 and have an 80 GB IDE hard drive in a firewire enclosure. When I reboot my system, the drive is not recognized. However if I unplug/plug the firewire cable, then the drive is recognized. I've included my dmesg output below. Any ideas on what is going on or what I'm doing wrong?
> da2 at sbp0 bus 0 target 0 lun 0
> da2: <Oxford S OXFORD IDE Devic 0132> Fixed Simplified Direct Access SCSI-4 device
> da2: 50.000MB/s transfers, Tagged Queueing Enabled
> da2: 76319MB (156301488 512 byte sectors: 255H 63S/T 9729C)
But my drive is not found during boot. I have to unplug/plug my firewire cable before my drive is recognized. Although I just found the fwcontrol man page and learned about the -r option. I ran it and my drive was found as well:
WARNING: driver fw should register devices with make_dev() (dev_t = "#fw/0") fwohci0: Initiate bus reset fwohci0: BUS reset fwohci0: node_id=0xc800ffc1, gen=2, CYCLEMASTER mode firewire0: 2 nodes, maxhop <= 1, cable IRM = 1 (me) firewire0: bus manager 1 (me) da2 at sbp0 bus 0 target 0 lun 0 da2: <Oxford 911G 0135> Fixed Simplified Direct Access SCSI-4 device da2: 50.000MB/s transfers, Tagged Queueing Enabled da2: 76351MB (156368016 512 byte sectors: 255H 63S/T 9733C)
But what is this "WARNING"? I don't recall seeing it on the unplug/plug sequence. Maybe that has something to do with my problem?
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"