Hey everyone. I have a confusing situation here with the new kernel. I just upgraded to 4.10, and in the process, decided to get a moderately updated kernel config. Particularly, I wanted to try to get my sound working again.
Here's the thing. I have the following lines in my kernel config: device pcm # Serial (COM) ports device sio0 at isa? port IO_COM1 flags 0x10 irq 4 device sio1 at isa? port IO_COM2 irq 3 device sio2 at isa? disable port IO_COM3 irq 5 device sio3 at isa? disable port IO_COM4 irq 9 options PNPBIOS You'll see the reason I've included the serials in a sec: The dmesg.boot file shows the following tidbits: pci0: <unknown card> (vendor=0x12eb, dev=0x0001) at 14.0 irq 5 and sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A and unknown: <PNP0501> can't assign resources unknown: <PNP0501> can't assign resources unknown: <PNP0401> can't assign resources unknown: <PNP0700> can't assign resources unknown: <PNP0f13> can't assign resources unknown: <PNP0000> can't assign resources unknown: <PNP0303> can't assign resources Now, The serials that showed up appear correct to me, but there isn't any sio2 or sio3, but the unknown card at pci0 is in on 5. Not sure if there's any connection. The things I'd like to resolve are the unknowns - to either correct or eliminate the things causing them, and to get the sound card showing up. The card is onboard in a Dell Optiplex G1, and before the last time I upgraded (thereby breaking sound) it was working fine with the aureal-kmod port. Problem is that I'm not sure if I should have the following: device pcm0 at isa? irq 10 drq 1 flags 0x0 Note that my fxp0 is using irq 10. Should I just change the irq? Should I leave it and/or the PNPBIOS line out? I'm sure there's some pertinent details I'm leaving out, so don't hesitate to let me know what it is. Thanks for the feedback. Lou -- Louis LeBlanc [EMAIL PROTECTED] Fully Funded Hobbyist, KeySlapper Extrordinaire :) http://www.keyslapper.org ԿԬ Where are the calculations that go with a calculated risk? _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"