LW Ellis wrote:
I downloaded the setiathome package. As far as I know everything went OK.
It would have been much better to use the port, which launches you straight into registration after make install. It's almost always better to use the port if there is one.
WHen I boot the system I get a message Run usr/local/etc/rc.d/setiathome.sh register to start seti I tried start with that line and got command not known
If you omitted the leading slash, this error is understandable.
I switched over to usr/local/sbin
setiathome start and got usr/libexec/ld-elf.so.1: Shared obj libc.so.4 not found.
I read the Seti read me
I looked in my book, and in the man pages.
There is no run command.
Start doesn't work.
Is my package installed wrong, or am I not typing the right command???
As typed above, you were not typing the right command. If your shell permits (bash et al), tab to complete each part of the path - saves time and typos.
You need a leading slash:
/usr/local/etc/rc.d/setiathome.sh register
HTH
Peter
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
