On Aug 5, 2004, at 12:54 AM, Stijn Hoop wrote:
# vinum list 2 drives: D vinumdrive1 State: up /dev/ad6s1d A: 156041/156041 MB (100%) D vinumdrive0 State: up /dev/ad4s1d A: 156041/156041 MB (100%)
0 volumes: 0 plexes: 0 subdisks: #
How early in the boot is this? Have you done 'vinum start' yet?
System is multiuser. "vinum start" has already been executed which was required to run "vinum list" shown above. vinum.ko is/was loaded.
If that doesn't work, does 'vinum read vinumdrive0 vinumdrive1' work?
No. Vinum replies: ** no additional drives found: No such file or directory Can't save Vinum config: No such file or directory
before vinum can create devices. You can force vinum to recreate the device
nodes by doing
Vinum replies: makedev is not needed for a DEVFS-based system
Am tempted to rerun "stripe -v /dev/ad4s1d /dev/ad6s1d" again but would rather not lose the data on the volume.
-- David Kelly N4HHE, [EMAIL PROTECTED] ======================================================================== Whom computers would destroy, they must first drive mad.
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"