I have one IDE disk drive with 40GB
I used the partition utility of win xp to make three partitions when I was installing 
winxp.  Its sequence is pri(xp)->ext(xp)->pri(bsd).
I installed the xp on the first partition(pri) and put some personal data on the next 
In the partition editor, I deleted(d) the third partition(pri) that I had made, then 
created(c) a new BSD partition.
Three partitions occupy 8GB. 16GB. 14GB in sequence respectively.
After testing, both of win xp and FreeBSD can run normally with no problem.
my question is ... does the FreeBSD still have the restriction that its root file 
system must be installed in the first 1024 cylinders???
the document as above point out should put the root file system / into the 1204 
cylinders of the first disk drive otherwise bsd can't start normally.
The book" FreeBSD: An Open-Source Operating System for Your Personal Computer" by 
Annelise Anderson  say "FreeBSD needs a few of its files(those in the / or 'slash' 
root file system)close enough to the front of the drive so the computer can find them. 
And every other operating system needs some files up front too..."

I used partition magic to see the cylinder range of my bsd partition.  It indicated 
the cylinder range of bsd had already gone beyond the 1024 cylinders! 
But I still can use booteasy to start both of these two os.   So I can't figure out if 
the FreeBSD was really restricted by the 1024 cylinders???

I think if it's about boot manager???
The common boot manager uses BIOS to start the os, but it's also restricted by BIOS.
The BIOS has the restriction that os can't be start if some files of os(just as / of 
bsd)go beyond 1024 cylinders.
But the booteasy doesn't use the BIOS, so it's not restricted by BIOS?
I had ever used OS-BS to boot these two os, the xp can start normally but the BSD 
can't. The pop up prompt window say"NO OPERATING SYSTEM!".   So I can't make sure if 
the factor"boot manager use BIOS or not" affects the 1024 cylinders?
[EMAIL PROTECTED] mailing list
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to