--- Fabian Keil <[EMAIL PROTECTED]> wrote:

> On Sunday 19 September 2004 14:55, BSDjunkie wrote:
> 
> > I have been using cdrecord since I built my
> system. I
> > have an Asus A7N8X delux motherboard, AMD 3200+
> cpu,
> > 2G of ram and (2) 15,000 rpm scsi drives.
> > 
> > I recently bought a Toshiba DVD+r/-r burner, which
> I
> > replaced my DVDr/CDRW drive with.
> > 
> > The new drive is detected at bootup:
> > 
> > acd0: DVDR <TSSTcorpCD/DVDW TS-H552B> at
> ata0-master
> > PIO4
> 
> Do you later see lines like:
> 
> cd0 at ata0 bus 0 target 0 lun 0
> cd1 at ata1 bus 0 target 0 lun 0
> cd2 at ata1 bus 0 target 1 lun 0?
> 
> If not, you probably need to add
> 
> device          atapicam
> 
> to your kernel configuration.
>  
> > However, cdrecord --scanbus no longer can see the
> > drive through scsi emulation.
> 
> What does it see?
> 
> Regards
> Fabian
> 

Other than what I mention in my post, there's nothing
more detected at boot-up.

I'll see if there's an option atapicam that I can
include in my kernel config file.

Thank you for the advice.

Mark
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to