On Friday 15 October 2004 05:32, Peter Seebach wrote:
> Hardware:  SuperMicro X5DE8-GG motherboard, dual Xeon 2.8Ghz, 2GB memory.
> Using onboard SCSI controller for disks, onboard IDE for DVD burner.  DVD
> burner is a Pioneer DVR-108.
>
> Software:  cdrecord and/or cdrecord-ProDVD.
>
> Problem:  CD burning Always Fails.  Failure mode is 100% repeatable and
> consistent:
>
>  cdrecord: Input/output error. write_g1: scsi sendcmd: retryable error
>  CDB:  2A 00 00 00 01 55 00 00 1F 00
>  status: 0x2 (CHECK CONDITION)
>  Sense Bytes: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
> 00 00 00 00 00 00 00 00 00 00 00 00 Sense Key: 0xFFFFFFFF [], Segment 0
>  Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru 0x0
>  Sense flags: Blk 0 (not valid)
>  cmd finished after 0.000s timeout 40s
>  write track data: error after 698368 bytes
>  Sense Bytes: 70 00 02 00 00 00 00 0E 00 00 00 00 04 08 00 00 00 00
>
> Mr. Schilling says "Install a non-defective kernel."  I am assuming that
> this doesn't mean "some other OS".
>
> Googling around on the CDB bytes turns up lots of people with cabling
> problems, especially on SCSI busses.
>
> Googling around on FreeBSD and 698368 turns up someone who needed the
> P1003_1B option added to a kernel.  (It's now just the _KPOSIX option, and
> it's already in there.)
>
> I got as far as putting in the atapicam and related devices.  This happens
> whether or not I leave the atapicd driver in place.  (dmesg output below is
> without.)
>
> I enclose dmesg and config file as attachments for perusal.  I am Very
> Worried by the observation that the CD is claiming a 3.300MB/sec transfer
> rate:
>
>  cd0 at ata0 bus 0 target 0 lun 0
>  cd0: <PIONEER DVD-RW  DVR-108 1.10> Removable CD-ROM SCSI-0 device
>  cd0: 3.300MB/s transfers
>
Hi,

I'm having _exactly_ the same problem... :-( Mine is a Pioneer DVR-107D, 
firmware v1.18 on a 5.2.1-REL-p11.

dmesg :
cd1 at ata1 bus 0 target 0 lun 0
cd1: <PIONEER DVD-RW  DVR-107D 1.18> Removable CD-ROM SCSI-0 device
cd1: 16.000MB/s transfers. 

I got the same reply from mr. Schilling and I haven't found any solution 
yet... Could it be something with the drives/firmware ?

Beni.
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to