Hello, The healthd does not seem to show the correct temperature on my system.
Right after the start-up, BIOS usually shows around 31 centigrade for the motherboard and 21 for the processor. However, this is what the healthdc is usually showing right after the start-up of the FreeBSD after the start-up of the computer: host.name 62.0 15.0 69.0 3096 0000 0000 1.46 1.50 3.31 5.03 11.86 -11.62 -4.80 Then after a few minutes of ideling, BIOS would show the temperature of the processor at around 30 or 35. healthdc shows this: host.name 72.0 38.0 70.5 3096 0000 0000 1.46 1.50 3.31 5.03 11.86 -11.62 -4.80 UPDATE: Above lines refer to the standard heatsink and Intel Pentium 1.8A Northwood processor. Right now, as I have installed Zalman Fan Mate 1, the healthd does not show the speed of the processors fan, while BIOS still shows it at around 1500 rpm. He is what I get if I run `healthd -d`: %healthd -d ************************ * Hardware Information * ************************ WinBond Chip: W83627HF ************************ Temp.= 68.0, 51.5, 70.0; Rot.= 0, 0, 0 Vcore = 1.46, 1.50; Volt. = 3.33, 5.03, 11.86, -11.62, -4.85 Temp.= 67.0, 51.5, 70.0; Rot.= 0, 0, 0 Vcore = 1.46, 1.50; Volt. = 3.33, 5.03, 11.86, -11.62, -4.80 Temp.= 67.0, 51.5, 70.0; Rot.= 0, 0, 0 Vcore = 1.46, 1.52; Volt. = 3.33, 5.03, 11.86, -11.62, -4.80 Temp.= 67.0, 51.5, 70.0; Rot.= 0, 0, 0 Vcore = 1.46, 1.50; Volt. = 3.33, 5.03, 11.86, -11.62, -4.80 Thanks, Constantine. _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
