Yani Karydis wrote:
Hello,
Since upgrading to 7.2-RELEASE, dmesg displays the following after
booting the system.
(probe3:ahc0:0:3:0): TEST UNIT READY. CDB: 0 0 0 0 0 0
(probe3:ahc0:0:3:0): CAM Status: SCSI Status Error
(probe3:ahc0:0:3:0): SCSI Status: Check Condition
(probe3:ahc0:0:3:0): UNIT ATTENTION asc:29,0
(probe3:ahc0:0:3:0): Power on, reset, or bus device reset occurred
(probe3:ahc0:0:3:0): Retrying Command (per Sense Data)
(probe3:ahc0:0:3:0): TEST UNIT READY. CDB: 0 0 0 0 0 0
(probe3:ahc0:0:3:0): CAM Status: SCSI Status Error
(probe3:ahc0:0:3:0): SCSI Status: Check Condition
(probe3:ahc0:0:3:0): NOT READY asc:3a,0
(probe3:ahc0:0:3:0): Medium not present
(probe3:ahc0:0:3:0): Unretryable error
sa0 at ahc0 bus 0 target 3 lun 0
sa0: <HP Ultrium 1-SCSI N2CG> Removable Sequential Access SCSI-3 device
sa0: 20.000MB/s transfers (10.000MHz, offset 8, 16bit)
<snip>
FWIW, same here, 7.2-PRERELEASE #0: Thu Apr 16 08:42:45 CEST 2009 amd64
and HP Ultrium drive. Did not notice any harm though.
--
per
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[email protected]"
