Lev Serebryakov wrote: > I have VirtualBox-based FreeBSD 8.1 installation (32 bit, VirtualBox > 3.2.8, WinXP/x64 host, but I thinks that host config is irrelevant). > > Two virtual HDDs are atteched to virtual SATA adapter (channels > 0 & 1) and CD/DVD attached to virtual IDE adapter (Primary master). > > I've used FreeBSD 8.1-STABLE builded about two months ago and > everything worked Ok with "Standard" (not AHCI) driver, root FS is > ad4s1a. > > I've updated FreeBSD today (12/09/2010) with csup & > buildworld/buildkernel/installworld/installkernel (GENERIC kernel). > > Nothing was changed in VM config/setup. > > Now it can not be booted because KERNEL doesn't see any HDDs and > can not mount root FS. It shows only "acd0" as "GEOM managed disk device". > > bootloader sees disk and reads kernel & modules without problems. > > I've tried to "load ahci" on boot prompt, but result is almost the > same. AHCI driver sees two channels, but got timeouts on both -- > oops, can not mout root FS again.
If ahci(4) also fails - at least enable verbose boot messages and send me all that ahci(4) reports. -- Alexander Motin _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[email protected]"
